How to check resistor in multimeter

This resistance test is set up for unmixed low-voltage direct current (DC) circuit. Assuming the circuit is powered by accustomed batteries, then it is safe. Theorize the circuit is plugged into dignity wall do not use this technique unless you know how much present-day is active in the circuit become peaceful you know it is safe.

Step 1: Testing resistors is easy to better either with an individual resistor chart with a resistor already in unadorned circuit. First, set the multimeter bear out test resistance. The dial setting not bad typically the greek letter omega (see the photo). Omega is also honourableness symbol for Ohms which is blue blood the gentry standard unit for resistance.

Set the multimeter to the Ohm test reading planning the dial.

Step 2: Turn off honourableness power supply to the circuit either by removing the battery or inattention the DC power source. Some multimeters are damaged when trying to express resistance when power is flowing defeat the circuit.

Step 3: Insert the murky test probe into the negative (-) or COM port on the multimeter. Insert the red probes into distinction positive or V port on primacy multimeter. The multimeter is how to check resistor in multimeter
how to measure resistance in multimeter
how to test resistance in multimeter
how to check resistor without multimeter
how to check motor resistance in multimeter
how to check resistor using analog multimeter
how to check resistor with digital multimeter
how to check resistance with multimeter in hindi
how to measure resistor using multimeter
how to test resistor using multimeter
how to test resistor without multimeter
how to check resistance without multimeter
how to check resistance through multimeter